You are not logged in. Would you like to login or register?



8/29/2016 11:08 am  #1


early model chev 283 / 396 / 427 cam bearing

Earlier models require a 2 hole cam bearing on # 5 along with machining a flat on the cam journal. Is this required when there is not a full groove in the #5 cam bore ?

 

8/29/2016 3:41 pm  #2


Re: early model chev 283 / 396 / 427 cam bearing

The '65 and '66 big blocks had a grooved rear journal and internal groove in the bearing, no groove in the housing bore.  Crane Cams says the cam groove is centered to the journal, .187 wide and .109 deep. Use cam bearing set for 65-66. 
I thought the small block always had a groove in the housing bore.
Graig in Wyo

 

8/30/2016 12:38 am  #3


Re: early model chev 283 / 396 / 427 cam bearing

There was some very early 265 and 283 blocks that also required a groove cut in the rear journal as well because there was no relief holes in the rear of the cam journal to bypass oil from the cam plug as well.

I am restoring a very old 283 at this time that requires that same journal design using an NOS GM cam


Pro Power Engine & Machine
Victoria BC Canada
www.propowerengines.ca
 

8/30/2016 7:45 am  #4


Re: early model chev 283 / 396 / 427 cam bearing

My bad there-guess I forgot.  Haven't seen one of those SB for a spell.  Now I will probably take in one of those 265 chevys that didn't have an oil filter.  Glad you had one in the shop to help with the question.
Graig in Wyo

 

8/30/2016 10:29 am  #5


Re: early model chev 283 / 396 / 427 cam bearing

No charge 
Glad to help


Pro Power Engine & Machine
Victoria BC Canada
www.propowerengines.ca
 

8/30/2016 11:23 am  #6


Re: early model chev 283 / 396 / 427 cam bearing

Thank you guys for the info

     Thread Starter
 

Board footera

 

Powered by Boardhost. Create a Free Forum


ADDITIONAL INSTRUCTIONS FOR ADDING PHOTOS: To add a photo to your forum post, you must use a link to an image hosted elsewhere. (1) Create a free account on an image hosting website of your choice; we recommend www.imgur.com. (2) Upload your photo and then copy the image link (http://www.example.com) from the image hosting website. (3) Paste the image link into your post using the image tool on the forum. If you have any questions, please email info@aera.org.