Since 1980 BK provided custom engine machining to SW Oklahoma. After transitioning business completely into the power system side of business this equipment has not been used for over 10 years but is in a climate-controlled shop. This equipment has original paint and has not been in a production setting. All surfaces and wear points are in excellent condition. Can provide photos or access to view upon request

85B SURFACER with insert cutter head and custom variable speed feed drive / Includes head table, fixture, jacks, parallels, level, block set up tooling and custom tooling to set deck height from crank centerline and deck angle. Great Machine & tooling.  ”Bought New”
 
F2B BORING MACHINE / includes 90 block cradle, production style boring head & mic,2.230-4.1 X 6 stub bar & mic, all set up parallels, Lots of tool holders for both bars & tool grinder, Custom stub bar for boring reamer tooling for lifter bore repairs in blocks with 90^ lifter bore angles & small housing or case repairs, Misc Harley cylinder fixtures & misc pancake jug engines.   This machine has original paint with spindle, wear surfaces in great condition. “Bought New”
 
PM2500 ROD BORING MACHINE with 5/8,1, 1 ½  bars with all setting tooling & bearings, face clamp plates, cross head fixture, all three pin end mandrels, perfect condition tool setting. There are tray cabinets with cutters and tooling all in pristine condition.  Must see to appreciate this machine. “Bought New”
 
CG8400 CAP GRINDER  / Includes all set up parallels and no wear on table or ways. “Bought New
 
RI9000E ELECTRONIC ROD GAUGE with all factory set up fixtures in excellent condition. “Bought New”
 
PH2000L HEAD MASTER MACHINE with quill digital travel indicator / includes factory roll over float bed, adjustable seat insert cuter and profile heads with mics, lots of fixed cutters and tooling, also includes custom air float bed for using BHJ SBC block true lifter bore tool with coolant tray & mister with custom collis quick connect tool chucks to drive cutters & reamers. “Bought New”
 
PRO BAL BALANCER with MSC 951200 mil-drill mounted  / Includes balance calibration rotor, arbor fixture & bob weights, CW-80 scales with rod fixture Works great & like new when purchased.
 
260 BERCO CRANK GRINDER / Good old machine spindle bearings good with few dings on bed, Has 2 grinding gauges, stone balancer, several mounted stones, in rack with hubs. Lots of centers, “Bought used but grinds great with lots of unpolished shafts setting in crank room to inspect.
 
Cabinets full of HS reamers, carbide tip reamers and solid carbide reamers.
Racks full of NOS engine parts, hard seat inserts, pin bushings, bearings,
Display racks of HP Crower valve train,  
 
                    GREAT EQUIPMENT FOR THE SMALL SHOP UPGRADING
 
B-K Engine Specialties Inc.
Shop   580-255-5825
Cell     580-251-0236
Email  bke@beitax.com

Last edited by davehagen (8/16/2022 11:28 am)