You are not logged in. Would you like to login or register?



12/14/2015 4:27 pm  #1


2.8/3.1 and Buick 3.8

I want a honing plate for a 1985-87 Buick 3.8, approximate dimensions are:
Bore would be 3.8"+, with a bore spacing of about 4.250. Bolts would be about 4.250 x 3.100. Dimensions measured with my caliper.

I am looking at a plate for a 2.8/3.1 C
heverolet. Other than boring it out a bit, would it fit?

Thanks

 

12/15/2015 2:09 pm  #2


Re: 2.8/3.1 and Buick 3.8

I know it won't fit anyone got one for a 3.8 they will part with?
 

     Thread Starter
 

12/19/2015 12:00 am  #3


Re: 2.8/3.1 and Buick 3.8

CCA Racing
They make them from 2" billet and they are very well made.
Not bad cost either.
I have about 10 of their plates in use and FYI they come with spacers for either bolts or studs just specifi when ordering.
They may even have some in their clearance stock

Dave


Pro Power Engine & Machine
Victoria BC Canada
www.propowerengines.ca
 

Board footera

 

Powered by Boardhost. Create a Free Forum


ADDITIONAL INSTRUCTIONS FOR ADDING PHOTOS: To add a photo to your forum post, you must use a link to an image hosted elsewhere. (1) Create a free account on an image hosting website of your choice; we recommend www.imgur.com. (2) Upload your photo and then copy the image link (http://www.example.com) from the image hosting website. (3) Paste the image link into your post using the image tool on the forum. If you have any questions, please email info@aera.org.