You are not logged in. Would you like to login or register?



7/20/2015 3:20 pm  #1


6.0L ford diesel cylinder sleeve

We got one in the shop today that is cracked at the top of the cylinder through the deck to a coolant passage. It extends about 1 " into the cylinder. Customer wants to save the block with a sleeve, but man the skirts on these cylinders are thin thin thin. Has anyone had any succes with these? I always get nervous on the first one of some jobs.

 

8/03/2015 2:13 pm  #2


Re: 6.0L ford diesel cylinder sleeve

Sonic test the lower part of The bore to be sure there is enough material to support a sleeve. You may have to stop a bit shorter like a 1/2" from the bottom and use a flanged top sleeve to make it work.


Pro Power Engine & Machine
Victoria BC Canada
250 652 6985
www.propowerengines.ca
 

Board footera

 

Powered by Boardhost. Create a Free Forum

ADDITIONAL INSTRUCTIONS FOR ADDING PHOTOS: To add a photo to your forum post, you must use a link to an image hosted elsewhere. (1) Create a free account on an image hosting website of your choice; we recommend www.imgur.com. (2) Upload your photo and then copy the image link (http://www.example.com) from the image hosting website. (3) Paste the image link into your post using the image tool on the forum. If you have any questions, please email info@aera.org.